Sounds to me like the machine needs a new developer or maybe it's overtoning a lot. Is it leaving spots of toner on the copies? It's also possible the recovery blade is worn out.
Sounds to me like the machine needs a new developer or maybe it's overtoning a lot. Is it leaving spots of toner on the copies? It's also possible the recovery blade is worn out.
If you are hitting your head up against a wall it always feels better when you stop.
Thanx a lot for becoming the first to respon....
May i ask the meaning of 'new developer'? is that mean to?? what i'm clueless
'Overtoning' i do put toner more than ussual, ussually = 0.5 Kg & now i put 1.0 Kg ( i think this is still ok )
Yes! it leaving spots on the copies,,, so the result is awfully ugly
But, i can sure you the blade is in perfect condition, tommorow i will provide you with picture... (cleaning time in the morning )
please do help me...
Proton,
It seems to me the machine needs a bit of love. Get a service manual and start with that.
If you are hitting your head up against a wall it always feels better when you stop.
The original post was in 2007. He most likely resolved the problem by now.
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads
Paul@justmanuals.com
Wow, that cleaning blade for sure has patina......
Hans
Do you do a recalibration after you clean it? I managed to keep a misbehaving one of these going for a few months between cleaning by cleaning every surface around the cleaning blade(I mean EVERYTHING cue tips and all.) and recalibrating the ADF sensor after i finished. If I didn't recalibrate it would just dump toner and next time I restarted the machine I would have to clean it again.
Just a far thought: Is the sensor for the rear machine cover in place (lower left corner at the rear)? If knocked out of place or otherwise not functional the machine will not calibrate properly.
Anyway, it looks the machine could need starter (developer), cleaning blade, antispill mylar and perhaps a new drum.
Hans
Definatly needs the antispill mylar. Also I would make sure the waste toner box isn't full.
Bookmarks