i have just checked the rollers seem to be in place properly (the one that has a soft coating) and they seem to be in alignment
any other ideas please... this is ripping my hair out stuff!!
i have just checked the rollers seem to be in place properly (the one that has a soft coating) and they seem to be in alignment
any other ideas please... this is ripping my hair out stuff!!
i have just checked the rollers seem to be in place properly (the one that has a soft coating) and they seem to be in alignment
any other ideas please... this is ripping my hair out stuff!!
Is the web operating correctly? Is the top fuser roller correctly fitted..with good heat shield bushes inside the bearings and is the pressure lever working..it lifts the lower fuser roller up towards the top one. Can you stop the sheet as it passes the fuser to see what is happening to it?
i have just noticed that the soft roller(anti curl roller) has lumps in it could that be causing the curl issue and on further investigation it is that A3 paper on the leading edge is curling and A4 paper on portrait is curling but on landscape it is fine any ideas??
Last edited by carneage; 06-15-2010 at 04:35 AM.
here are a couple of photos of the page as it comes out of the printer.... please help .... i am losing my mind on this one!!
can any one tell me if the decurl roller should be very soft to the touch and out of round to the finger when spinning it in position?
Great the de curl roller is soft as a kitchen sponge, i will replace .... can any one please tell me where to find a good ... cheap replacement for this that will ship to australia... i think the part number is 56AA53070? is that correct
thanks all for your help
i am glad to be able to see a light at the end of the tunnel
got a new decurl roller and it works perfectly... thanks for all your help everyone
Bookmarks