Can't seem to find out what this code means. It happens intermittently. Can anyone tell me?
Can't seem to find out what this code means. It happens intermittently. Can anyone tell me?
PROBLEM:At times an SC23-03 can be displayed.CAUSE:When the machine is operating in a high temperature, high humidity environment it is possible that M2 does not
rotate at the proper timing.SOLUTION:The circuit board of M2 has been redesigned to prevent the code from being displayed.
i copied this from database so here is the thing old part number for this part was
4024-202501 the new one is 4024-2025-02 it gets rid of the code. it actually works i have had the problem myself. anyways good luck
so just curious if you were able to fix the problem
I have gotten this code a few times on our 650. I dont know about the first time, but this most recent time it was caused by the toner recycling tube not being installed properly in the down / open position. That caused a backup of toner which apparently resulted in the mt-2? motor slowing or not turning at all....
When I tried to lower the corona engagement lever it wouldnt drop so I had to remove the large gear on the toner recycler, then rotate the auger by hand to discharge the backup of toner in the tube. After that, I reinstalled the large gear, closed the doors and power cycled the machine. That cleared the code , it ran for awhile clearing toner I suppose. After that I removed the dv unit, vacuumed the toner from under it, and am now trying to clean up the copies.
Bookmarks