bizhub 500 code 2803

[salmoz]

We are struggling with this code since two months. First I like to thanks all the friends for the support are giving me. Then I followed the two advices of pepper and saw that there are no drive problems. The gear turns a third of a revolution then stops I havent yet tryed to unseize it. The screw on the solenoid look to me normal not too long not too short but I will check more thoroughly.
I add That the code appear at the start up of the machine and the TCR adj gives error 6 constantly. Actually is beeen giving the same error even when the machine was perfectly working that mean since the first change of dev and drum.

[pepper38_cnd]

If you are getting the error 6 almost instantly after starting the TCR adjustment, it is usually the sensor in the drum carriage is dirty or a High Voltage problem.