Many Thanks
"Many years ago I chased a woman for almost two years, only to discover that her tastes were exactly like mine: we both were crazy about girls."
---Groucho Marx
Please do not PM me for questions related to Konica Minolta hardware.
I will not answer requests or questions there.
Please ask in the KM forum for the benefit of others to see the question and give their input.
look at your cyan corona, if not that, back roll your cyan mag roller and see if it improves.
Could also be a bit of fuzz or something between the laser and the drum. Area under the dev unit is particularly prone to this. Remove the transfer unit and the cyan drum then use a flashlight on the area directly under the dev unit. Fuzz is sometimes hard to see.
Had the same exact Problem. Look at the cyan developer toner roller, you should see a even coating of toner across the length of the roller. In your case there is going to be a gap or a light coating of toner on the area of the stripe. Take a 2" wide strip of 80lb gloss, an feed it in the bottom portions of the roll approx 1-2" until it stops. Then move the strip left and right across the length of the roller. There is a blockage preventing even toner distribution, this will losen it up and should correct your problem.
Thank you Vanman I will do it and let you know.
Bookmarks