Thanks:
0
Likes:
0
Dislikes:
0
-
Trusted Tech
50+ Posts
- Rep Power
- 34
konica 7022 j20-4
Manual says its system emergency stop
so what a hell is that?
How can i fix it?
-
Trusted Tech
50+ Posts
- Rep Power
- 30
Never ran into that one but this was in the 7020 guide...
Solution ID TAUS0611031EN* Solution Usage 7
Description
J20-4 only when making copies in the 1:2 or 2:2 mode.
Solution
CAUSE: The jumper for the copy vendor connection is loose. When the ADU gate solenoid (SD5) actuated, the vibration caused the copy vendor connection
to open signifying a stop signal.
SOLUTION: Reform the jumper on the copy vendor to allow proper contact with the connector.
Sounds like it thinks the key counter was pulled.
-
Trusted Tech
50+ Posts
- Rep Power
- 34
It also happens on 1:1....
So any more ideas ?
-
Trusted Tech
50+ Posts
- Rep Power
- 30
The only info I see on that code is related to the key counter. If the jumper contact is bad or the wiring to it are shorting it could do it at any time. It's as if the machine thinks the key is being pulled mid-copy job. Try setting dip sw 1-0 to 0. That lets the copy job finish even if the key is pulled mid job. Maybe re-flash the firmware or as a last resort re-initialize the machine.
-
Trusted Tech
50+ Posts
- Rep Power
- 34
thanks HuronMan ,
1-0:0 did it....
-
Trusted Tech
50+ Posts
- Rep Power
- 30
Good deal. Glad I could help.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks