Thanks for your help, don't have 30-10 anymore, but now I'm getting 39-01, as I understood that is fixing sensor, do you know where is it, don't really want to take entire machine a part.
Thanks for your help, don't have 30-10 anymore, but now I'm getting 39-01, as I understood that is fixing sensor, do you know where is it, don't really want to take entire machine a part.
It is fixing sensor related, that is, the temperature sensors are involved, however....The extremely helpful (NOT) service manual for this machine has the following entry on this error code...
"Fixing section has not been set"
That said, the TSB entry on this code relates the following...
Description
SC39-01 or F-3901 at power up.
Solution
PROBABLE CAUSES:
1. A damaged fuser connector on either the fuser or main body.
Inspect the two fuser connectors on the fuser and the two connectors for the fuser on the main body. Ensure that they are aligned and not damaged.
2. AC Drive Board has failed.
Replace the ACDB (p/n 65AA-9520).
The location of the ACDB is, looking from the back side of the machine, lower right hand corner, near where the AC power cord goes into the machine.
It could simply be a poor connection is being made, most likely at the rear side of the fuser connection. But be sure to check all the physical connectors to ensure they are properly seated. This could possibly involve the connections on the CDB itself that you replaced.
"Many years ago I chased a woman for almost two years, only to discover that her tastes were exactly like mine: we both were crazy about girls."
---Groucho Marx
Please do not PM me for questions related to Konica Minolta hardware.
I will not answer requests or questions there.
Please ask in the KM forum for the benefit of others to see the question and give their input.
Thanks a lot will check
Bookmarks