Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 5 of 5
  1. #1
    Service Manager 1,000+ Posts
    bizhub 7145 Strange Image Problem

    mrfuser's Avatar
    Join Date
    May 2007
    Posts
    1,557
    Rep Power
    51

    bizhub 7145 Strange Image Problem

    Getting a white area on the page. Op side of page as it exits. Pull DV unit out and we notice that the DV is light or missing on the area in question and the defect is the same as the DV roller, therefore obviously the DV roller, BUT, when we turn the DV by hand it coats even and fine. Put back into machine and get same result! What is causing the DV to move from that area of the roller only when installed?

    Thanks!

    Kelly

  2. #2
    Da Boss 100+ Posts BIG PAPA's Avatar
    Join Date
    Jan 2010
    Location
    The Great North
    Posts
    234
    Rep Power
    31
    Just a guess, but possible that the magnet in the roller broke, and when spinning by hand not getting enough rpms's to notice defect.

  3. #3
    Head Tech 500+ Posts SmellsHot's Avatar
    Join Date
    Dec 2009
    Location
    Sault Ste Marie, MI
    Posts
    512
    Rep Power
    35
    Could be clumps in your developer. Inspect developer and replace if at all clumpy. Have seen this quite a few times.

  4. #4
    Field Supervisor 1,000+ Posts RRodgers's Avatar
    Join Date
    Jun 2009
    Location
    San Bernardino
    Posts
    1,951
    Rep Power
    56
    I would say you are low on dev. Check for leaks and refill it. (change dev)
    Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.

  5. #5
    bladerex
    Guest
    Quote Originally Posted by RRodgers View Post
    I would say you are low on dev. Check for leaks and refill it. (change dev)
    RRogers may be right.
    Also check do you have good bias in the roller.
    Measure resistance between bias plate and magnet roller to see.
    If it's more than 20 Om you need to change the bearing of the mag roller or to adapt a spring between bias plate and roller axis.
    It is by the way good solution to stop the developer leak of this machines.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here