Cyon color printing problem CF2002

minoltakee · 02-16-2011

Hello, I need someone's help who know to solve my problem. Last time when a paper was jammed during copying both side, I pulled it out by hands. After that, my Minolta CF2002 has had problem in color printing. only cyon color does not fit exactly on the image as the attached picture shows. In order to fix the problem, I have changed lots of parts including Fuser assembly unit, Cyon imaging unit, and transfer belt unit. However, same result shows. Can anybody help me? sm_Image.JPG

**fixthecopier** · 02-16-2011

The print head is most likely the culprit.

**JSC** · 02-16-2011

The LED's are well known for going down on his model, swap the cyan with the one of the others and see what you get.

minoltakee · 02-16-2011

Thanks for your reply. I am very new technician. What is the LED? Where is it? How to change it? Please, let me know. Thanks again.

Originally Posted by JSC

The LED's are well known for going down on his model, swap the cyan with the one of the others and see what you get.

**tmaze01** · 02-17-2011

hi
i just have a question regarding removal of printhead from a cf2002 i have been lucky to remove one from a junk stripped down one and ARE YOU FREAKING KIDDING ME? it didnt take that long (however this machine looks like a palm tree wires brackets etc.. everything is exposed ) is there a standard procedure to remove an led p/h without gutting the machine out. any help is appreciated

**JSC** · 02-17-2011

This is a LED machine it does not use a laser to wright the image on the drums it uses LED's, from memory to remove the LED bed you take out the iu's and transfer belt, open both side doors, remove the waste bottle, remove the rear side cover to unplug the led bed, remove the 2 holding screws, push in and turn the iu drive couplings a 1/4 of a turn so they stay pushed in, then pull out the led bed from the waste bottle side of the machine. Then the fun bit is removing/swaping the leds from the led bed.

Good luck