Di 2510

[KHAN]

HI, I HAVE Di 2510 IT RUNS FOR 167200 COPIES NOW I WANT TO REPLACE THE DRUM,CLEANING BLADE AND DEVELOPER,WHEN I WANT TO ENTER THE SERVICE MODE ,AFTER PRESSING THE UTILITY+METER COUNT THE COPIER ASK FOR CODE I ENTER EIGHT TIMES 0 AND THEN END I GET THE TECH MODE AND I REPLACE THE KIT,
THE QUESTION IS CAN I CHANGE THAT PASS WORD. I WANT TO ENTER MY OWN CHOICE PASS WORD ?

IN THE DEVELOPER UNIT THERE IS A FUSE WHAT IS IT FOR , I JUST REPLACE THE DEVELPOER AND RUN F8 . WHEN AND WHY WE CHANGE THE FUSE ,
PLEASE I NEED HELP FOR THIS
THANKS TO ALL

[Rudi]

It Is Very Dangerous Playing With That Code , Because If Maybe You Forget Or Maybe Leave Without Anyone Knowing The Code It Is Quite A Process To Get Into The Mode As You Have To Either Replace A Board Or Down Grade Your Firmware To A Specific Earlier Version And Then Upgrade It Again In Sequence. But I Will However Check And Get Back To You On That I Think It Is Somewhere In The Warm Rastart Menu. As For The Fuse I Have Never Seen It Myself.

[wagon]

The Di2510 has no fuse in the image unit. If there is something in there, behind the plug, it will most likely be a resistor. Don't touch it - you don't need to! And I agree with Rudi : leave the password standard - if you change it, and forget it later, it will only cause problems.

[KHAN]

thanks For Your Help,yes It Is A Resister In The Unit,what Is It For ?

[wagon]

I would guess the resistor is just there to tell the machine that
A) An image unit is in the machine
B) The image unit is the correct type

Kendall.

[Rudi]

OK , i found out about the password change it is the security mode i.o.w you go into the service mode and then push stop 9 then it will give you the option , have fun.

[KHAN]

thanks For Your Kind Help.
god Bless You All ?

[wagon]

That is OK! Anytime I can help I will!

Kendall.

[Rudi]

More Than Welcome Bro, Apreciaciate The 2510 , As It Might Be One Of The Last Minolta Machines We Will See.

[halia_merah]

HI, I HAVE Di 2510 IT RUNS FOR 167200 COPIES NOW I WANT TO REPLACE THE DRUM,CLEANING BLADE AND DEVELOPER,WHEN I WANT TO ENTER THE SERVICE MODE ,AFTER PRESSING THE UTILITY+METER COUNT THE COPIER ASK FOR CODE I ENTER EIGHT TIMES 0 AND THEN END I GET THE TECH MODE AND I REPLACE THE KIT,
THE QUESTION IS CAN I CHANGE THAT PASS WORD. I WANT TO ENTER MY OWN CHOICE PASS WORD ?

IN THE DEVELOPER UNIT THERE IS A FUSE WHAT IS IT FOR , I JUST REPLACE THE DEVELPOER AND RUN F8 . WHEN AND WHY WE CHANGE THE FUSE ,
PLEASE I NEED HELP FOR THIS
THANKS TO ALL

I'm Agreed with Rudi. It's very dangerous to change your service mode code.And I don't think It can be change for this previous model.But You can change admin password that default is 00000000.