error code 0094 on a Konica Minolta C35

[atiq]

I have a error code 0094 on a Develop ineo+ 35 (Konica Minolta C35), machine is dead asking to ring service quoting trouble code 0094.

Please advise - Thanks

[bizhub1]

That code has to do with the 2nd transfer pressure/retraction or the idc shutters are not opening/closing

[atiq]

Thanks for that, I will let my engineer know of this.

[Zeldaman]

Hi there!
Remove the the transferbelt-unit and rotate the band manualy (check if it´s going easy) & rebuilt the unit. Also look that there is the newest firmware on the machine (attention: it exist G10 & G00 Versions!).
Greetings...

[Mr. Joshua]

Make sure the second transfer release solenoid isn't hanging up due to the pad that's there to minimize noise. See the attached pic. This pad had gotten sticky enough that it was delaying the action of the solenoid. Took a lot of service calls to figure this out!

[pallmarton]

Hello ,

can you help me where is this pad located in the machine exactly?

Thanks

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[MFPTech]

Make sure the second transfer release solenoid isn't hanging up due to the pad that's there to minimize noise. See the attached pic. This pad had gotten sticky enough that it was delaying the action of the solenoid. Took a lot of service calls to figure this out!

Hi
Thanks for the post. I am dealing with the same issue and so far replaced the ITB, checked the solenoid (there was no pad I could see), inspected the ITB guide and ordered the updated one. Noticed that the new ITB was very noisy so I put the old one back....
Has anybody else dealt with this code please or has any other ideas please.

Thanks in advance!

[minimerlin]

Remove the ITB and then remove the 4 springs that are visible holding the Magenta and Yellow 1st transfer rollers in tension. Refit the belt..if code stays away you are supposed to remove the belt and refit the springs after stretching them a little to reduce their tension but not so much that they fall off!!
The springs are too tight so that the drives cannot operate the shift assembly, hence the noise and then the code!

Sorry ...Just realised that I have missread the error code!! Please ignore my post..talking about 0096 code.

[blackcat4866]

Here are a few possibilities:

"0094", "0310" error. 2ndary transfer drive failure (0094), and laser shutter malfunction (0310). Enduser has removed the fuser, then only latched the fuser at the front. The rear prevents the right door from closing completely. Re-install fuser and latch correctly. Close right door.

"C0094" error. Transfer rollers popped out of place. Rotate the pressure gear. Shadow @Copytechnet

"C0094" error. Flimsey clutch in the transfer unit on the door won't rotate and open the shutter over the IDC sensors. Replace door. Speedy @Copytechnet

"C0094" error. TAD [TABT1200333EN00]. Secondary transfer problem. See Bulletin. minimerlin @Copytechnet

=^..^=