The door switches are pricey for what they are .. but they always fix this problem !!!, I don't bother to clean them very often ... but then again I don't see as well as I used to, and my fingers aren't as nimble either ...
Mike
Well, I used to clean / repair the switches on the older models, unless they were microswitches ... remember the ones on the old KOnica 1803, 2803, 3290,s etc ... the customer would shut the door so hard they'd bend the metal actuator ! and some of teh old mita's that had three separate switches in the interlock !! ... was always fun trying to fold a piece of paper to cheat that switch !!
Believe it or not, I went to school to be an electronics technician .. 26 years ago I answered an ad for a copier technician trainee ... Hmmmhhh ... still doin it .............. must be something in the toner that's addictive ??
Mike
I can't say much of Konica, but I've seen a few Sharps do this. The front door interlock closes intermittently, cutting off the 24vdc to the HVT. If your getting 20 ohms @ the interlock when closed, the main board still sees the door is shut, but not enough current to run the HVT.
bros, i have a konica 7033, my problem is that: at the start of the copying, the first copy is clear, but as at multiple copies, the image become light. so i got light copies problem.
i have read your post about the front door interlock switch to replace the switch that might cause light copies.
i tried to isolate the problem by shorting the orange wires-front door interlock and the shorting the red wires just to know if the problem will be solve, but the problem still exist. intermittent light copies as you run.
for your information i'm a former service engineer of Fuji Xerox machines for 15 years. i resigned and put up my own business center.
i solved my trouble problems on konica 7050 machine.
i solved F54-1 on 7033. my problem isthe light image as you are copying.
could somebody advise me of what other probable causes of the problem?
please help..
Replace the charge corona assembly, if you dont have one restring the wires themselves, hope this helps
I agree just change the interlock switch.... But if you are certain its not the switch then change the T/S carona, are you getting any codes? Check management list, they may be recorded and not displayed, codes would really help.
if you have not solve the problem yet, you may check for developer clutch. it might be slipping.
Bookmarks