Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
250+ Posts
- Rep Power
- 31
Minolta C253 (Develop Ineo +253)
HELP
In warm up, get a clicking noise like gears not meshing then comes up replace waste toner tank. Checked fuser seems ok, just rplaced approx 2k ago.
Any suggestings
-
Is the itb belt set correctly?
i ve had an issue with the rear of the uint no messing!
-
Da Boss
100+ Posts
- Rep Power
- 31
Also check the waste toner system(arm that empties into waste toner). Might be clogged.
-
Since the machine is telling you to check the waste toner, I would start there. The clicking sound could be a loose auger in the waste toner hopper, or the reclaim on the ITB or intake on the waste toner could be clogged, as BIG PAPA suggests.
-
Technician
- Rep Power
- 27
i have same problem like that, its cause from toner clogging, check toner supply unit, toner supply drive is same with waste toner drive, so if the toner supply is clogging, the waste toner also having problem.maybe its a little bit difficult, because if you want to clean toner supply you must overhaul the machine.
-
Senior Tech
100+ Posts
- Rep Power
- 0
Re: Minolta C253 (Develop Ineo +253)
its any loose contact at tcr sensor of each i u unit .so so toner pumps continuosly for that unit,so u have to remove cloging in toner pipe .than auger will rotate freely,other wise same sound repeats.be carefully open behind all to clean toner pipe.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks