Results 1 to 6 of 6
  1. #1
    Senior Tech 100+ Posts CrapAimer's Avatar
    Join Date
    Jan 2010
    Location
    Glasgow
    Posts
    153
    Post Thanks / Like
    Rep Power
    11

    Angry Minolta C253 (Develop Ineo +253)

    HELP

    In warm up, get a clicking noise like gears not meshing then comes up replace waste toner tank. Checked fuser seems ok, just rplaced approx 2k ago.

    Any suggestings


  2. #2
    Technician


    scanzmgs's Avatar
    Join Date
    Jun 2011
    Posts
    11
    Post Thanks / Like
    Rep Power
    7
    Is the itb belt set correctly?
    i ve had an issue with the rear of the uint no messing!


  3. #3
    Da Boss 100+ Posts BIG PAPA's Avatar
    Join Date
    Jan 2010
    Location
    The Great North
    Posts
    234
    Post Thanks / Like
    Rep Power
    12
    Also check the waste toner system(arm that empties into waste toner). Might be clogged.


  4. #4
    Kronic Copier Ninja 100+ Posts kronical's Avatar
    Join Date
    Nov 2009
    Posts
    231
    Post Thanks / Like
    Rep Power
    13
    Since the machine is telling you to check the waste toner, I would start there. The clicking sound could be a loose auger in the waste toner hopper, or the reclaim on the ITB or intake on the waste toner could be clogged, as BIG PAPA suggests.


  5. #5
    Technician engineer's Avatar
    Join Date
    May 2011
    Location
    jakarta
    Posts
    19
    Post Thanks / Like
    Rep Power
    8
    i have same problem like that, its cause from toner clogging, check toner supply unit, toner supply drive is same with waste toner drive, so if the toner supply is clogging, the waste toner also having problem.maybe its a little bit difficult, because if you want to clean toner supply you must overhaul the machine.


  6. #6
    Senior Tech 100+ Posts
    Join Date
    Jul 2010
    Location
    vizag
    Posts
    106
    Post Thanks / Like
    Rep Power
    0

    Re: Minolta C253 (Develop Ineo +253)

    its any loose contact at tcr sensor of each i u unit .so so toner pumps continuosly for that unit,so u have to remove cloging in toner pipe .than auger will rotate freely,other wise same sound repeats.be carefully open behind all to clean toner pipe.


Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •