Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
250+ Posts
- Rep Power
- 37
Re: Konica minolta c500 pro (sc77-25 code)
I have no history on this machine
the pm counts says 93762 meter count 837899
i checked the sensors in the fuser and in the duplex unit in 47-59-3 mode
fuser senor changed from 00 to 01 when i tested it the one in the duplex unit did not change, so i replaced it and tested it again. Still not signal. Is this the sensor you are talking about when you say "exit sensor just past the fuser"?
-
Re: Konica minolta c500 pro (sc77-25 code)
Well, I don't know your circumstance, but you might consider doing some maintenance and bringing FW up to date (v.14-something-or-other?), if you haven't already. At the very least, give that squishy decurler, and its attending area, some attention (100K item).
As for PS19 (item #4), it's located just beneath the decurler (item #3) in the vertical turnover section (that door with all the clear guides that the decurler lives on).
I don't know about you, but 8050/C500 was a box that enjoyed notorious oversales. It's a production machine that likes to run. Unfortunately, too many sit, at well under 1M after years.
That left side decurler door, in particular, can get flat nawsty.
Good luck. Keep us posted.
-I
Last edited by Ianizer; 07-12-2011 at 01:57 AM.
-
Senior Tech
250+ Posts
- Rep Power
- 37
Re: Konica minolta c500 pro (sc77-25 code)
This is what i finally discoverd. For the j32.02 code driving me crazy. The "paper exit guild part" (p\n 65aa49100) was not working properly because it was broken. But.... Befor i discovered this fairly easy repair solution i had already replaced:
The svdd driver board
the fuser
the adu solenoid
the m29 motor
ps 19 twice
the harness to ps19
ps 17
was getting ready to relpalce the reserse exit solenoid sd6 when i noticed the exit guide was not working properly, and was in fact broken.
Long way around a short trip. Like taking 40 years to make a 11 day journey!
Thanks for all your help!
-
Re: Konica minolta c500 pro (sc77-25 code)
All just goes into the great big experience coffee can.
-I
-
Trusted Tech
50+ Posts
- Rep Power
- 24
Re: Konica minolta c500 pro (sc77-25 code)
for next time,you will do it in a few minutes,i also have a problem with an sc77-23 error on konica 7085 and it seems that i will take the journey you had till i solve this matter,maybe somebody there can help me out.copy count 4129510,
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks