Originally Posted by
habik
OKAY
here are some codes
T81-
T81 Call control
Dial Tone detection NG when CML
is turned ON at calling
The line may not be connected.
Check the line connection status.
R07-
R07 Reception
Image information does not come
in image information waiting.
The line may be disabled because
the user on the remote station disconnected
it.
switched off ECM..and had slight improvement, lowered TX/RX speed to 14k bps , not much of improvement, Initialized fax board to default, slight improvement.. took the whole board out and waited for 5 min than slapped it back in. worked for a while could send and could not receive, than could receive and not send..frustration kicked in..until
customer complained about internet connection...asked where is their MAIN connection socket and found that fax line is run of broadband line through adsl filter. So my biggest suspicion is the actual BB line,
Have you come across a problem like this? Thanks for suggestions. M
Bookmarks