I still have not had any luck myself or with a help response. Went back in on this thing and i can run Letter R with staple. I ran 11x17 with staple and runs fine. When i run 81/2x11 it gets j72-19. I watched the paper coming out by fuser exit to finisher and you can see the pause at end of set with the letter r and the 11x17. The 81/2x11 just goes throught the machine with no pause between sets and the 1st copy of the second set gets to ps5 to early. It only does this with staple selected. Is this firmware or something else?? I am pretty sure it is not a finisher problem. Thanks in advance for any help.
Later Pudgi300
Bookmarks