Plz. Somebody. Anybody. C352 no light from display/op. panel

[SKTeK315]

What's up all ?
Plz., no light from bulb. Contrast only does just that. Makes LCD ELEMENTS ON SCREEN GET DENSEER, (more visible & fade away when VR turned opposite. If it's not the op-panel then WHAT ???

[Gaffers01]

I think there is actually a lamp in the display, its the bit under the touch display with (White casing) that needs to be replaced.

[SKTeK315]

I think there is actually a lamp in the display, its the bit undeMoy the lamp. r the touch display with (White casing) that needs to be replaced.

Not the lamp. Changed 2 then op panel. If not the panel or the bulb nor the ribbon cable, then...?

[acusso1234]

Check the connection of the silver connector on the right side of the machine. Sometimes give problems.

[SKTeK315]

Check the connection of the silver connector on the right side of the machine. Sometimes give problems.

Seems ok. It's only the display lamp that's effected. Nothing else. Contrast dims & brightens the LCD bits but no light

[copytechman]

Likely blown icp on scanner board if you can see the screen but it's not backlit. Either repair the icp or replace the scanner board iirc.

Regards!
A.

[SKTeK315]

Likely blown icp on scanner board if you can see the screen but it's not backlit. Either repair the icp or replace the scanner board iirc.

Regards!
A.

That's what I thought. Tnx. What's icp ? Is that the board behind & lower of the ccd ?

[copytechman]

Yeah, hard to describe the icp exactly but if you've had dealings with them before you'll know what to check.

Regards!
A.

[JustManuals]

This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com