Is this suction fan the m12 fan in this machine where is it located. keep getting this error code does anyone have a solution for it.
Thank You
Is this suction fan the m12 fan in this machine where is it located. keep getting this error code does anyone have a solution for it.
Thank You
from C250ver_3_08.pdf
It is located under the filter on the upper rear of the box...clean it!!!
... In the minute that you're thinking of giving up, think about why you lasted so long ...
[QUOTE=acusso1234;245644][ATTACH]11781[/ATTACHi
I have cleaned it and it spins should I replace it?
Could this solution be of help?
Workaround for failing fans..., ...here fan M17 of Minolta Di-450
Hans
You could reverse M12 with M13, why are the same, and see if the error code changes or not. This way you can tell if you have to replace the fan or the card. But if there was an ICP burned on the card, the code would be fixed and not intermittent as in your case.
... In the minute that you're thinking of giving up, think about why you lasted so long ...
Is it PWB M that need to be replaced for this code because i tried a new M!2 fan and code still comes back
Thank You
ahh bugga: I have C351 and the same Issue:
I ordered new fan...and in the meantime tried one from another machine, which wasn't installed "also" properly wires tend to get squished between the mainframe of the door and the metal support plate which is also acting like a earth..
I also tend to find the foam touching the fan-- every now and then and I think this could cause that intermittent issue.
If I cut it out that the suction will be not as good and could cause build up of paper dust.
FW or anything simmilar did not work for me...unless there is a specific solution to this. Probably Board..(ouch)
This is wrong. The right one is Suction fan motor M10 (9313 1000 72) 2011-09-23_094319.jpg
Hi,
I have the same problem, error c-0301.
Machine is C252.
Machine was working ok before holidays and after few days in cold room it shows error and jam paper when paper goes from paper tray to registration section.
I visually check 3 fans on the back of machine, they are working,somebody mention pwb-m,is it a problem?
Bookmarks