Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
250+ Posts
- Rep Power
- 31
konica 7145 j-30
i have a konica 7145 that jams as it comes out of fuser and i get a j30. it comes 2 inches out of machine like it would when you have wrong paper size chose on paper dial. the machine runs fine if you use bypass. i have run singles through top drawer and they jam but not always. exit sensor and actuator look good. nothing broken. seams to do better out of drawer 4 not nearly as many jams but when it does its the same jam. all rubber is clean and good. any ideas. thank you for any advice
-
Senior Tech
100+ Posts
- Rep Power
- 32
Re: konica 7145 j-30
The lower fuser roller can have a flat spot all across it and cause jams
-
Senior Tech
250+ Posts
- Rep Power
- 31
Re: konica 7145 j-30
replaced upper, lower fuser roller and fuser exit switch. customer says its better but still get some j30 jams
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks