Bizhub C220 Bypass Tray Sensing Problem.

[Glaander]

First of all, did you set this machine up as new yourself? if yes, did you do the following

did you follow up the set up step by the manual?

on the machine is using KM toner or 3rd party? if 3rd party toner that might be why the problem on the toner level sensor not working.

[Abrantes]

12.4.20 Manual Bypass Tray AdjustmentA. Use

• To set the maximum width and the minimum width for the bypass paper width detectionresistor of the manual bypass guide.• Use when the bypass paper width detection resistor of the manual bypass guide hasbeen changed.• Use when a false paper size is displayed when the manual bypass is used.

B. Procedure

1.

Call the Service Mode to the screen.

2.

Touch these keys in this order: [Machine] → [Manual Bypass Tray Adjustment].

3.

Touch [Max. Width].

4.

Load the bypass tray with paper having a width of 297 mm.

5.

Press the Start key and check that the results are [OK].

6.

Touch [Min. Width.].

7.

Load the bypass tray with paper having a width of 100 mm.

8.

Press the Start key and check that the results are [OK].

✽ Make the adjustment again if the results are [NG].

Thank you.
I had this no recognising SRA3 problem and found this tread before oppening my manual.
my mistake was trying to make the setup using an A4 (297 width) and "the mistake" A5 (1/2 A4) for smal width
the information about 100mm minimum width saved a trip to my car.