Dislikes:
0
-
Technician
- Rep Power
- 17
Re: bizhub 250 C2557 error code
I service about 50 of these machines at a local college and have seen c2557 alot. I was going crazy trying to figure out what was going wrong. I would change the developer unit,drum and starter together. The machine would run about 2000 copies and the code would come back. I tried changing the "A" board, there is a bulletin about changing a fan,nothing worked. The problem turned out to be the solonid in the toner drive mechanism.I've done about 8 of these and not one has come back. What happens is it starts to stick. If you tap it with your finger you can see that it doesn't pop up all the time. Order the entire assembly, don't change just the solonid.
-
Re: bizhub 250 C2557 error code
We had a large fleet of these machines and still have some. Changing the sticky patch of the solenoids in the Hopper Drive Unit (page26, position 46 parts manual) was enough. No need to replace the whole unit. Patches must be replaced with anything non-magnetic with a similar thickness. Just leaving them out will not work.
Lot of work to take the Hopper Drive Unit out. When re-installing, after replacing the sticky patch, take care that the marked bushing fits in the corresponding hole in the rear frame of the machine otherwise you'll face a new problem.
bushing PICT3224image010.jpg
After doing the above, you might try to raise the ATDC Sensor Gain to 165 in the hope that the machine will accept the over saturated developer. If drum and developer are not too old you might try to use the procedure Woxner described otherwise you have to replace at least the developer and follow again the procedure from Woxner.
Good luck
Hans
" Sent from my Intel 80286 using MS-DOS 2.0 "
-
Technician
- Rep Power
- 21
Re: bizhub 250 C2557 error code
I know it may be a little bit offtopic, but is it possible that same reasons can occur in bizhub 222 with same C2557 error code?
I do have one machine which constantly does it, we had to change it for the customer, now it's sitting in our office and I would like to revive it
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks