Hello everybody
In which direction do you have the lines?
KM send the Old drum DU102C modified with a high pressure on cleaning blade. It is necessary to have the firmaware rel.70 and patch GN-70 to work with those drums. With this software version you can adjust some dipswitch to avoid Error code C.22xx, and make some break.
About lines, the pressure of blade is high, and the surface of drum stick a little bit, sometimes the cleaning blade jump and give fine lines. Often if the room temperature (and into engine) is high, also if the customer production is high (from 8000 prints a day).
To solve your problem you need to adjust some pauses, (break) with the dipswitch. (if you have rel.70 installed), if not you can not solve your problem which is caused by the drum itself.
Kind regards,
Twinax.
Bookmarks