One of our clients machine has come up with the following code:
“Machine Trouble Service Call (13F0)”
I have a rough idea it could be one of the dev units.
Regards
Atiq
One of our clients machine has come up with the following code:
“Machine Trouble Service Call (13F0)”
I have a rough idea it could be one of the dev units.
Regards
Atiq
There are three types of people in this world: those who make things happen, those who watch things happen and those who wonder what happened.
From the book:
13F0: Engine control failure
Relevant electrical parts
Print control board (PRCB) MFP board/1 (MFPB/1)
1-Check the cable and connector for proper connection and correct as necessary.
2 Change PRCB.
3 Change MFPB/1.
Hans
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
Has this been resolved please?
Toda i had a brand new machine out of the box with this error. The machine initializes the scanner and fuser, stays in warming up phase for a while and instead of going to Ready it throws the error. The fuser is hot.
The service manual says it's an engine error and recommends rebooting the main unit. Tried to write firmware but the moment I turn the machine to bootrom mode the error led is on.
Thanks in advance!
Bookmarks