Hi guys,
need help, refer to the attachment.
already confirm the TS belt is ok, internal print same problem.
any idea??
Hi guys,
need help, refer to the attachment.
already confirm the TS belt is ok, internal print same problem.
any idea??
If i see good it is only red color doubled...?
Check imaging units,esspecialy magenta and yellow.
Bad IU's I would think. Do a single color copy of something for each color and see which is giving you an issue.
Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.
Crappy photo.
Is that A3? And the image repeat is in the main scan direction? In Magenta? I'd wager a magenta laser malfunction... After eliminating the easiest/cheapest possibilities, try to swap the magenta laser with another color.
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!
No problem about the photo, we do what we can with what we have. Just be sure to give as much info as possible next time.
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!
Go into service mode, test mode, and kick out a gradation print of all 4 colors invidually. This will narrow it down.....
Everyone has the right to be stupid. Some people just abuse this privelage more than others
Check the two green levers on the fuser aren't pushed all the way down in the envelope position. Have seen this cause double image and dirty copies. Levers should be flicked up for normal printing
Dear All,
the problem solved by changing the M IU.
Bookmarks