I am getting an error code C-3911 on this machine at powerup. Can someone please tell me what this code means?
I am getting an error code C-3911 on this machine at powerup. Can someone please tell me what this code means?
It means your fuser isn't reaching temperature and you need to call a service technician.
"In a cruel and evil world, being cynical can allow you to get some entertainment out of it."
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
I am a Ricoh technician and we replaced this machine with one of ours a few months ago. The machine has to go back to the leasing company soon and I just need to get a copy out of it. Its been sitting in our warehouse in the cold and Im hoping that it was just too cold to come to ready temp. Can anyone tell me the reset procedure for the fuser code?
power on holding utility...
in service find i/o
enter 3-1
Set to 0
move up a digit and back down make sure it took.
power off. reboot normally.
if you have a cracked lamp or bad anything with the fuser may not clear.
Whts the machine config? will the lease let you buy? what your price? what the meter? is it a C6500 or C6501?
I have same problem with CF2002.
It keep saying 'warming up' because my machine is in cold room.
But when i restart machine again, it changed to another message like 'warming up, ready soon to copy', then i can use the copier after short time.
Might fuser is already warmed up.
You can restart machine again (with on/off) to see the message is changed or not.
i would check your fuser wire connection in the front of the machine...
but how cold is the room?
Bookmarks