Konica 7272, IP-511a

[copyman]

i tried several times to input the IP,subnet & gateway on the copier op panal but will not hold the address. after i put in the address and then print out the config page it still has the old Ip address on it. i tried it many times doing different things like backing out, powering machine off and on, etc. what am i missing? thanks in advance

[jagan]

once you put the ip address, you need to come to one menu up and their is option which says update NIC. you need to do update nic it will as the password enter sysadm

[matt34]

I have been having the same problem! I have updated the NIC very time time but when after the machine updates the IP address is "Not Configured". The only way I have gotten it to work is to use the autoconfig option which is a pain because everytime the machine is turned off the address changes and I have to reinstall the print drives in the computers. Any suggestions? Any at all!?

[tervel12]

If you can get the NIC to grab an address, then input that address into a web browser and change the IP address there. Be sure to uncheck the Auto-configure or DHCP option. The password is: sysadm (all lower case).

After you apply this setting, just wait about 5 minutes and it should print out a new status page with the IP address.

[BizHead]

Remember to check the function " Store in nvram"

[jt888]

I had the same problem. Konica 7272 wouldn't not take the ip address manaully.
However, it did finally when I changed the temporary ip address to the static one through the web manage. However, now I'm unable to web manage the static ip address. The static ip address ping fine and I'm able to scan and send documents via email. Anyone has any idea? I disable the AppleTalk and Netware.