please help for administrator password (Konica Minolta Bizhub Pro C5500)

[technosystems]

Ahmed,
I have used this PS file before (a long time ago) to retrieve the admin password. Try the following steps
1: open command workstation and log into the fiery (guest is ok)
2: click on File-Import
3: navigate to where you have the password.ps file located
4: select "Direct" as the location (not "print" or "process and hold" or "print and hold")
The machine should print a page with the admin password printed.

I dont know whether the later system fierys will print the password. I believe system 9 and above will not.

The ONLY other alternative is to reload the system software. I know you want to avoid this but it is the ONLY way to reset the password to Fiery.1

you mentioned that you cannot see the operating system for the fiery (display goes blank after the windows xp load screen). This is normal for a Fiery. You have to have the "FACI" option installed for the server type fiery's (IC303/305). The embedded fiery (IC408) does not have this.

Good luck.

Thanks Dear, I'll try to do. but after taking a backup from hard disk as an ghost image. to exclude system re installing >> ok?

[mohammad fayaz]

check this passwrd
12345678
or
00000000

[JustManuals]

This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from:

Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[technosystems]

It will print the password on almost all Fiery's. It may come out as a hash md5 printout (I think that is the correct one). Then google a hash to ascii translator, type it in and there is the password.
Usually you use the operational panel to access the fiery or via the network. Unless it has a faci kit and option monitor/keyboard/mouse.

Dear, i bought my machine from France, so my fiery system by French language
Fiery option on machine monitor by French
Printing options on any computer on network by French

Did you know any way to can replacing it with English ??

thanks,

[ZOOTECH]

Dear, i bought my machine from France, so my fiery system by French language
Fiery option on machine monitor by French
Printing options on any computer on network by French

Did you know any way to can replacing it with English ??

thanks,

Reload system software, it will prompt you for the language.

[technosystems]

Reload system software, it will prompt you for the language.

I don't have My system software, so i want to do it without new installation on machine controller

My Fiery is : Fiery x3ety2-10

I have fiery software command workstation 4, and i installed it on another computer on network, but i don't know if it's the same of machine controller or not