bizhub c224e network problem

[occus]

Hi

I have a problem with a bizhub c224e. I have no connection.
Special, between the PC and the machine is a switch to a other room, cable ~10 meters

I have 10 machines and all have worked. If i connect a other machine it works perfect.
i have tested a direct connection between the PC and the machine after it works!

-Test with IP address dhcp and static...
-reset of network in service mode.. nothing

Same firmware of all machine Firmware G20-63

What is the difference?

Any ideas? thanks!

*edit
-i changed the PC and the switch... nothing works

the machine get a ip address from router but i have no ping, no web interface and no print connection from PC, from router i have a ping connection..

[a4o7910]

Service mode.Sistem1.contr.0

[a4o7910]

Web pages.ip

[a4o7910]

Cabel is not cross on the swich

[a4o7910]

Its a machin embeded controler?

[TheOwl]

Try slowing down the NIC speed to something like 100 MBit Half Duplex or 10 MBit Half duplex and see if there is still an issue.

Also, depending on how the infrastructure is laid out, you might want to try hanging the machine directly off the switch and bypass the cabling in the wall as this could also be an issue.

Test with a PC conntected to the outlet where the copier is plugged into and see if that works. Sometimes switches of a low quality or cabling which is compromised can cause MFD's to not receive a link as they are unable to negotiate and speed with the switch.

[blackcat4866]

Try slowing down the NIC speed to something like 100 MBit Half Duplex or 10 MBit Half duplex and see if there is still an issue.
... Sometimes switches of a low quality or cabling which is compromised can cause MFD's to not receive a link as they are unable to negotiate and speed with the switch.

That was my suggestion. I've seen this on the previous incarnation (C280, C360). In my situations one test page would print then the connection would drop. Reboot, one more page would print, then connection drop. =^..^=

[occus]

Thanks for reply

1. yes i use the embedded controller, it's a new machine out of the box.(standard adjustments)
2. Test with slow down the NIC speed, problem persists.

The other machines are working with no problems on the same port/cable/switch...
So i can say the switch and the cables are not the problem.
There is a difference between the machines but i don't know what.

Adjustments are all the same.
I use the infrastructure for so many ineo+220Sseries and for more than 10 ineo+224e but this is the first one with network problems.

[emujo]

I notice you have the MFP at ver G20-63. This version is only for the LK (web browser) enabled MFP. If you don't have the LK installed then this may be causing the issue. Emujo

[pajeroid]

Did you solve the problem? I have a machine which is doing the same. It's an Olivetti MF222plus which is the same model.

My problem is slightly different, all machines cannot print when the machine goes tits up. I have tried lowering the network speed. It also has User Authentication on, is this the same for you???