Bizhub 501 paper jamming in registration area

[vijaysharma]

Hi,

I'm facing the jamming problem in Bizhub 501. problem area registration clutch.

what i done, I checked registration clutch it is ok registration sensor also ok


secondly i checked the PRCB board it is ok, checked the OACB board also but problem is not rectify,

is anyway to solve the problem

[JustManuals]

This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from:

Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[mo0651]

I don't know what you mean by checked clutch?!? These clutches are known problems. There are two different ones right there. Change them both while you have it apart.

[copier addict]

mo0651 is right. Replace the clutches in registration area.

[emujo]

Hi,

I'm facing the jamming problem in Bizhub 501. problem area registration clutch.

what i done, I checked registration clutch it is ok registration sensor also ok


secondly i checked the PRCB board it is ok, checked the OACB board also but problem is not rectify,

is anyway to solve the problem

I opened the side door and the clutch did not fall out, there is a registration sensor in the place I think it's supposed to be, I didn't see any smoke pouring from the PRCB or OACB so they should be OK also. It must be a piece of crap machine that can't run a single piece of paper and needs to be replaced, not my troubleshooting skills. Emujo

[vijaysharma]

Hi again

mo0651 thanks

i replace the clutch, registration sensor,PRCB board and OACB board also

but the problem is not rectify

[copier addict]

Hi again

mo0651 thanks

i replace the clutch, registration sensor,PRCB board and OACB board also

but the problem is not rectify

What jam code/codes are you getting?

[mo0651]

Jam codes?? There are two clutches there, Did you replace both? Are the rollers turning?

[vijaysharma]

HI,

jam code is J-3100

[vijaysharma]

again

both clutches replaced and rollers not turning