Hello ,
After unsuccesfull firmware change one of our Bizhub 420 stuck's on lit display only.Is there a way to reset the firmware to factory?
Hello ,
After unsuccesfull firmware change one of our Bizhub 420 stuck's on lit display only.Is there a way to reset the firmware to factory?
try downloading and installing the oldest level of firmware on the KM site.
check for any special firmware as well.
$hit Happens - Deal with it and move on.........................................................................Lock & Load
Alrdy tryed that but the display is still only lit with power LED on ...
It worked after removing both batteries on the MFP board..
thx
Last edited by copycommerce; 10-17-2013 at 03:05 PM.
Bookmarks