BizHub C253 blank pages

[copyman]

Blank (no image) copies & prints,happening with color and B&W. No error codes.

I did see the tech bulletin about replacing the PWB-PH board.

Anyone else ever see this? Account is far away and want to make sure to bring anything else it could be.

Thanks in advance

[wseyller]

Check that the transfer belt is driving. I've seen the belt get damaged to the point where it gets stuck and the drive slips and will cause blank pages.

Sent from my DROID BIONIC using Tapatalk

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


http://www.justmanuals.com


Paul@justmanuals.com

[Canon.Tech]

Start my stopping the machine mid run see if there is an image on the transfer belt & image units

[copyman]

Thanks for the help. Turned out the transfer belt was completely torn apart. Special thanks to wseyller, because of his post I had the transfer belt with me.

Really strange that it did not throw a code with a torn belt. I thought a sensor reads the edge of belt for movement?

Anyway all is good and machine is working now.

Thanks Again

Happy New Year

[blackcat4866]

Not so strange really. In all the equipment I see, I can say the only transfer errors I've ever seen were primary transfer shift in the Kyocera Saturns. Even when the primary transfer belt is tangled in the pulleys, the only warning you'll get is some gear noise, and jamming.

Oh wait, and on the Kyocera Alphard series there was some problem with the primary transfer belt shifting to the rear, but that was resolved with updates to the transfer belt assy. =^..^=

[slimslob]

On most Ricohs you will get ID sensor errors, but they only logged and not displayed on the panel.

[wseyller]

Good to hear you got it going

Sent from my DROID BIONIC using Tapatalk

[copyman]

There were several "P" warning codes but these type of codes dont stop the machine. The customer didn't see the oil can on display. If they would have told me about the oil can I would of had them read me the codes and if there were several P codes realted to Trans belt I would have figured it had to be something with that.

Just to clarify I have seen these belts tear but never this bad with complete blank page. Also damaged the black Image unit by some of the belt getting fed into unit and scratching drum.

[gabitzzup]

Hi, Can someone help me.

Bizhub c253 printing blank pages,
the Transfer Belt Is god, I change the PWB-PH and the same, change relay Board, change mainboard, change Hv Board.
I'm stuck now.

Please Hellppp.
Thank You.