That wouldn't lock the machine up. Your "locks the machine" crappola is why no one suggested that obvious solution.
That wouldn't lock the machine up. Your "locks the machine" crappola is why no one suggested that obvious solution.
Don't be too harsh, how many "tech/IT" induced problems have you run into? Some of my biggest headaches have come from a tech changing a setting and not "mentioning" the change. Emujo
If you don't see your question answered in the forum, please don't think it's OK to PM me for a personal reply...I do not give out firmware and/or manuals.
This reminds me of a problem I had on an MFD years ago.
I could get it on the network and ping it, loaded drivers but it just wouldn't print.
Lights flashed receiving data and the job would be deleted with no log.
Turned out it didn't have a pcl board installed just the standard Canon UFR II.
Same fault on a different device some years earlier there was no print board installed at all.
Just my 2pence worth but might be worth looking at the print board.
I have no knowledge on the bizhubs so what I have said may not apply but I hope it helps.
Bookmarks