I probably need to look further into the machine then you see the other day before I found the rollers to clean I could not even get one copy to duplex now I just ran a set of 50 copies two-sided was like 12 originals in a day great I was curious though how to even clean those rollers down below it seems too hard to remove the lower plastic rollers and access that said a feed rollers any suggestions? I do appreciate your reply



Brent


There is a set of mylars deep in there that rip all the time for me on this model. I remove them and the problem never comes back. There is also a black pad guide attached to the mylar and it is in the turnover section below fuser. This problem can be intermittent and kicked my butt first time.

You will not see them without removing the guide or really getting perfect angle underneath. I think your problem will come back.[/QUOTE]