Hello, is there a procedure for removing the lens assembly! I had to replace the image processor board and had to remove the lens assembly to be able remove the board, and I think I removed the wrong screws! There are three screw in a triangle that are on the edge of the frame and two screws that have springs that I also removed! after replacing the image processor I am getting a code (lamp detection) I forgot the code!!! and yes the lamps come on! when I set the lens assembly down with out tightening the screws it goes through the process without error! I made the mistake of removing screws with paint, I know how stupid!! I feel bad as it is! I think that the screws that I was supposed to remove were the two screws on both sides and the frame slips through the three mentioned screws! is there a procedure to get those realigned also? any help would be great!! Thanks!
Bookmarks