Thanks:
0
Dislikes:
0
-
Senior Tech
100+ Posts
- Rep Power
- 0
C353: transfer belt and C-2152
Hi all,
just replaced a T/Belt on a C353, after a week it throws a lot of C-2152 errors, on power on and on doing jobs also.
Refitted the old transfer belt and the errors are gone away.
I've been reading all the related post here on copytrechnet and all the service bullettins on konica minolta smartcontact, and this is my question: can a modified (last version) transfer belt give this issues on a copier where the modification kit isn't installed?
Anyone here can give me the correct part number for the original and modified transfer belts?
I'm asking those question because this is the first time for me when a new original transfer belt is worse than the old, and i never had any issues on new original transfer belts before.
-
Re: C353: transfer belt and C-2152
one of the fixes is to pack self cut mylar spacers under the plastic block on the side of the transfer belt that touches the actuator in the back of the machine to bring it closer. Check if the old belt was modified in this manner and do the same to the new one, or do it anyway.
-
Junior Member
- Rep Power
- 0
Re: C353: transfer belt and C-2152
Replace M1 transport motor , they are bad for going out or weak turning the transfer belt.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks