BIZHUB 754E C-1141

[jujitsu47]

C-1141 Intermintently jams, any ideas would be appreciated....

[EarthKmTech]

And you've done what so far ?

And what finisher is installed ?

[laitang]

Paddle motor’s (on finisher) drive malfunction

Your finisher is FS-534 or 535?

[jujitsu47]

And you've done what so far ?

And what finisher is installed ?

FS-534 and not much, its daily and often but not every copy? ck'd sensors and motor in service mode

[habik]

FS-534 and not much, its daily and often but not every copy? ck'd sensors and motor in service mode

Re- # sensors NOT in service mode!

I had one which was OK in Service mode I/O check and day later it wasn't OK in I/O check..

so sensor out and meter out!

[giddyupngo]

Hi, just wanted to mention I had this code today, after taking apart the FS-534 finisher, there was excess white grease on the timing wheel, which got into the PS14. Replaced sensor and tested OK. However strangely enough in Service mode the state of PS14 didn't change from 0 to 1. However running the paddle motor in Service mode worked.
PS14.pdf

[bronco31]

Hi, just wanted to mention I had this code today, after taking apart the FS-534 finisher, there was excess white grease on the timing wheel, which got into the PS14. Replaced sensor and tested OK. However strangely enough in Service mode the state of PS14 didn't change from 0 to 1. However running the paddle motor in Service mode worked.
PS14.pdf

i cant find the Load Check in the BH808 Service manual for running M5, the paddle motor.. in the FS=536 finisher?