hello
I have a bizhub C452 that I swapped. Set the password of the service, of course I do not know.
I tried ...... 1 8-92729272 - 0 .... 0, but nothing to do.
there is some procedure to reset it.
thanks
hello
I have a bizhub C452 that I swapped. Set the password of the service, of course I do not know.
I tried ...... 1 8-92729272 - 0 .... 0, but nothing to do.
there is some procedure to reset it.
thanks
Hi, I do,
stop 0 0 stop 01
from service mode stop 0C end you rewriting the PWD
bye
If you don't see your question answered in the forum, please don't think it's OK to PM me for a personal reply...I do not give out firmware and/or manuals.
Cause I'm getting old..and stay off my lawn! Emujo
If you don't see your question answered in the forum, please don't think it's OK to PM me for a personal reply...I do not give out firmware and/or manuals.
This is absolutely useless if you dont know the password to enter service mode in the first place.
If you cant access service mode because you dont know the password you will have to use NVRAM recovery jig firmware and completely reconfigure machine again. And not being able to go into service mode before hand means a guaranteed "licence management error" too. You should probably contact KM support.
Firmwares HERE.OK Google! ... will I need Berrocca this morning?
the firmware nv ram recovery can not find it for the C452.
is only available for the C451.
EarthKmTech, can you give me confirmation?
Bookmarks