I have an FS533 inner finisher that has been giving me a fit. Issue follows accessory so I'm safe in assuming its not a machine issue. Here is what happens. When given a print or copy job the machine will start up and then pull paper. when the job is ready to exit the machine the finisher tray doesn't lift. Then the job exits. Now when you run the next copy/print job the machine will fire up, and then stay there till it displays a jam situation. None of the jam indicators are highlighted, but an error 99-08 is shown. The job is lost from the Que, and may go back to working normally for a time. I have replaced the Finisher Board and have tested it on several other Main Frames. With the same results. Also it appears that stapling, sorting, grouping, etc has no change in the issue. any thoughts on this would be helpful.
Thanks
Kevin
Bookmarks