Konica 951 Fs532

[jaredfmn]

We have a pro 951 B&W that the finisher when doing sorting single sided copies or printing. The copies will sometimes fly off the lower exit tray or stack unevenly. We have swapped the entire finisher and the problem still persists????? Any suggestions? the firmware is up to date as well.

[fajdoooo]

We have a pro 951 B&W that the finisher when doing sorting single sided copies or printing. The copies will sometimes fly off the lower exit tray or stack unevenly. We have swapped the entire finisher and the problem still persists????? Any suggestions? the firmware is up to date as well.

Hello,

I had a similar problem on the device pro950 with FS-528. On the upper part of the output shelves , I glued a more hard plastic which pressure the paper down against the shelf. It was assumed that the paper slowly comes to shelves and for this reason , the following are bumps into him. I wil put some pic next time I will be at the coustomore.
BR

[manuelcorrea]

It's weird that both finishers would do the same thing. Check the springs that are behind the 4 fingers that press down on the stack of paper. Sometimes they break.

[fajdoooo]

It's weird that both finishers would do the same thing. Check the springs that are behind the 4 fingers that press down on the stack of paper. Sometimes they break.

I found some pic. what happend at my finisher. If someone had any IDEA how to fix it, please helpIMG_0371.jpgIMG_0378.jpgIMG_0377.jpg

[habik]

Shit Paper. Try landscape print!


Sent from my iDon't believe in marketing device using Tapatalk

[fajdoooo]

Shit Paper. Try landscape print!


Sent from my iDon't believe in marketing device using Tapatalk

I tried vith 3 diferent papers, same sh.. I tried landscap and it was bether, but same sh.. I even replace finisher vith new one, and it was ok for around 2,5 mio prints. Then the problem come back. Any sugsetion?

[fajdoooo]

This is how we temporary solved a problem

[habik]

Nice one

I wonder, have you tried adding anti-static brush to the exit section of the finisher and ground the brush and the tray?


Sent from my iDon't believe in marketing device using Tapatalk

[fajdoooo]

Yes I did. The maschine is all metall, and the finisher is also metall.

[blackcat4866]

Has anyone found a more permanent solution? For me, it's stapled sets of two pages. The staple makes one end significantly thicker, and the stacks leans and twists. It seems to affect thicker sets much less. =^..^=