I am having some intermittent snake pattern banding about 1 inch wide. Seem like a charge issue. Anyone had that issue? Anyone found a solution?
I am having some intermittent snake pattern banding about 1 inch wide. Seem like a charge issue. Anyone had that issue? Anyone found a solution?
Post a sample
Defects are simple, our mind is complicated
Have you done anything? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Well...., he made a post about it.....Have you done anything? =^..^=
Hans
" Sent from my Intel 80286 using MS-DOS 2.0 "
Well If you have maglev looking like snake you may have dodgy toner. Or damp dev unit. They are not rare this time of season.
Sent from my iDon't believe in marketing device using Tapatalk
Firmwares HERE.OK Google! ... will I need Berrocca this morning?
Hehe, remove debris from iu
Is there a mouse in the copier, they usually attract snakes.
The greatest enemy of knowledge isn't ignorance, it is the illusion of knowledge. Stephen Hawking
Laser unit bad!!
I try replacing drum and transfer roller with problem coming back. I did replace the dev unit and put fresh dev mix and problem is finally gone. I am trying to post a sample. Still not sure what was the problem. On the snake pattern I can rub off what feel like dev mix.
Bookmarks