C351 - bypassing the IC-402

[bicouncz]

Hi everyone

I would to ask some question.

We have KM C351 with EFI Fiery controller IC-402.

In IC-402 HDD will go to hell.
My idea is disconnect the IC-402 and plug the C351 to the network directly.
But if i unpluged main cable from IC, on main display in KM show "Power ON the Controler".
In the main menu on KM doesn´t config the TCP/IP network
So. This is the firmware problem i think, it´s true?
I have not login credential to KM bussines site.
It´s possible send me the correct firmware for my printer?
Thank you for any idea and sorry for my bad English :-)

ROM Version
MFP Controller BOOT Program	4037-1E00-G00-05-000(00)
MFP Controller SubSet Program	4037-1F00-G00-21-000(00)
MFP Controller	4037-0100-G00-D6-000(00)
Operation PANEL Message Data	4037-8100-G00-C5-000(00)
FAX Board Controller1
FAX Board Controller2
IR	4037-0023-G00-15-000
PRT	4037-0050-G10-28-000
LPH	4037-0053-G01-00-000
ADF	4582-24G0-08-00
Finisher
System Controller	4037-1000-G00-D6-000(00)
Printer Controller
Printer Controller-Font
Printer Controller-Demo Page	4037-3E00-G00-00-000
MIO	4037-5000-G00-47-000(00)
PSWC	4037-5100-G00-89-000(00)
MIB IF	4037-5200-G00-44-000(00)
IPP IF	4037-5300-G00-04-000(00)
External Controller IF	4037-6100-G00-44-000(00)
TCP/Socket	4037-6300-G00-15-000(00)
Open API	4037-7000-G00-86-000(00)
Operation PANEL	4037-8000-G00-C6-000(00)
CSRC	4037-8300-G00-67-000(00)
PIC	4037-8200-G00-16-000

[EarthKmTech]

If you want to remove and throw away the firey this is not a problem, you just need to change the controller number in service mode back the internal number - which I do not remember. It is is in the service manual, which i do not have for these anymore. Someone else will chime in shortly I'm sure. It is really not a big deal and not a firmware issue.

[bicouncz]

Thank you EarthKmTech.

I made it!

1) Go to service menu Stop-0-0-Stop-0-1
2) Service2 - Controller Unit - 0 Controler Unit (turn off controler)
3) Reboot
4) Done!

All function in administration menu(eq. TCP/IP setting and soo on) is back.

Do not know if it´s possible Czech translation for main menu? We have english only...