Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 5 of 5
  1. #1
    Technician
    Join Date
    Feb 2015
    Posts
    19
    Rep Power
    19

    c450 fuser needs to be replaced

    Bought a used fuser about 3 months ago. Installed it. Worked great.

    Last week the machine told me that the black IU, the transfer belt and the fuser needed to be replaced. This happened all at once. I expected this to happen to the IU and the transfer belt; so I replaced the IU and replaced the fuse on the transfer belt. The notices on both went off.
    However, when I replaced the fuser with another used fuser which I purchased, the notice did not go off. I tried to reset it by holding the utility button down and turning the machine on. It just sits there saying that it is warming up (13 minutes) - which it is not.
    I jumped the resistor on the fuser of the one that had been in there. I jumped it using a 100mA fuse in a fuse holder. No luck.

    Both fusers will warm up, but the machine says to replace them. Help!! Could this be a motor/gear problem? Where would I start looking?
    Thanks

  2. #2
    Field Supervisor 500+ Posts
    c450 fuser needs to be replaced

    Elmo's Avatar
    Join Date
    Feb 2010
    Location
    up north
    Posts
    535
    Rep Power
    41

    Re: c450 fuser needs to be replaced

    I i remember right you need to use 80ma fuse

  3. #3
    Technician
    Join Date
    Feb 2015
    Posts
    19
    Rep Power
    19

    Re: c450 fuser needs to be replaced

    Quote Originally Posted by Elmo View Post
    I i remember right you need to use 80ma fuse
    Thanks. Did not know that. I tried this jump over the weekend, but will order a new resistor, just to replace the blown one.

  4. #4
    Field Supervisor 500+ Posts
    c450 fuser needs to be replaced

    Elmo's Avatar
    Join Date
    Feb 2010
    Location
    up north
    Posts
    535
    Rep Power
    41

    Re: c450 fuser needs to be replaced

    make that a 63ma fuse just found some old notes on the fuser

  5. #5
    Technician
    Join Date
    Sep 2014
    Posts
    28
    Rep Power
    20

    Re: c450 fuser needs to be replaced

    100ma fuse should be fine, I done it yesterday on a 250. We had a problem with a 450 not blowing fuses, never got to the bottom of it as new boards were simply to expensive. Ended up we downloaded a firmware version that let us set the fuser to no stop and let us disable the end of life warning. If you need any info pm me

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here