Thanks: 
Likes: 
Dislikes: [hlo evry body please i have taskalfa 300 ci it dosnot scanning double sided in single pass .and it give me massage (you can't make dubl e side scaner) please any one can helpe me and thanks to all
[hlo evry body please i have taskalfa 300 ci it dosnot scanning double sided in single pass .and it give me massage (you can't make dubl e side scaner) please any one can helpe me and thanks to all
Run simulation u906...update firmwareOriginally Posted by falah taan
Clean White Reference Roller
You may have a bad CIS and fan
hlo thanks.but I have tow taskalfa 300ci the other one also give me the same error ( that you canot make to face in feder ) and I have no firmware of it .pleas if you have firmware .send it to me on my mail ( fa64lah@yahoo.com ) and thanks to you for reiply
Firmware will not solve your problem.
Like Has Been said, most likely the CIS cooling fan failed, allowing the CIS to overheat.
Resetting the error in U906 will last only long enough for you select duplex, then press start.
Run U000 Event Log. Most likely you'll find C3210 errors. Your display probably reads: "Cannot use 2-sided original due to a failure", preceded by "C3210"
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Reply With Quote
Bookmarks