Hi Folks...
Hope I can get some help/ ideas for my problem
Have a 3050ci that gives skewed output on all cassettes and bypass , most noticeable on 11 by 17. Lead edge is OK ,trailing edge and sides are off. U034 test pattern confirms skewing. The skewing is consistent. Not 100% sure ,but the image on the transfer belt seems skewed.
I have tried the following without success.
U051
Reg Roller
Holder middle pulley with modification and new springs
k-Laser unit
Entire paper conveying unit
Transfer belt.
entire laser assy.
Tried adjusting(left side of copier) laser assy without any change.
Removed, cleaned and re-seated all dv and drum units.
Adj color reg manually and auto...AND flashed firmware
At this point I have run out of things to try and the customer is PISSED....ANY help,ideas or suggestions would be much appreciated
THANKS.
Bookmarks