resetting KM-3035

[bigjoshua]

I need to reset all settings on this machine to factory default. How I can do it?

[jimbo1]

Sim 002.

[kyoceradude]

	Quote:			Originally Posted by jimbo1
	Sim 002.

That will only move scanner frames to left in order to lock them down.

You actually need to perform sim 020 reset data.

[jimbo1]

I'm new to Kyocera still.

[kyoceradude]

Not a problem.... We are all still learning. The day you know it all and are content, is the day you die....

[bigjoshua]

Folks, can someone give to me turn by turn directions, How can I do this mysterious Sim 002 reset

[Fangers]

U002 will only move the scanner rail to the far left of the machine to lock it in for transport. It doesn't change any settings.

You can clear everything using a U020 reset, however doing so will clear some settings such as machine destination, DF registration, paper timing values ect, so you should print out a maintenance list (U000) first so you've got a copy of these values.

[blackcat4866]

You should be absolutely sure you want to do a lobotomy on your 3035.

Even with the maintenance report it can be very difficult to restore all the settings. I have only run 020 a few times and usually regret it. And it doesn't fix anything.

=^..^=

[bigjoshua]

ok
here is my problems: I got 3035 week or so ago. 3035 have passwords everywhere and nobody know it. It is out of waranty and service.
My goal is Removing all passwords and adjust settings to comply with our network and so on.

[10871087]

	Quote:			Originally Posted by bigjoshua
	ok here is my problems: I got 3035 week or so ago. 3035 have passwords everywhere and nobody know it. It is out of waranty and service. My goal is Removing all passwords and adjust settings to comply with our network and so on.

if this is what you want to do then Then DO NOT run a Sim020 reset.

If you have admin passwords on your print system then you will need a tech to reset the card with a jumper to remove the unknown password.