Dislikes: 0
Hello All,
I have an Olivetti D-Copia 16.
It prints the image ok. The problem is that it gives a spotted or a taint in the other side of the plain paper the not printed one.
Any guess to where the problem is will be greatly appreciated.
Thanks in advance!
Last edited by koaslosa; 06-05-2016 at 05:49 PM.
The problem is that it has some cheap non-oem toner inside. If you look closely, you can notice the light gray background on the printed side too. To remove it you will have to vacuum the developer unit (it's mono-component, so it's fine), put the oem toner in, and run U130 to replenish.
Are you sure about that Kyo Fan? This looks like a Sharp re-badge to me (Puma or Jaguar). =^..^=Originally Posted by Kyo fan
Olivetti D Copia 16.jpg
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
That appears to be the 16W whereas the 16MF looks like a 2550. I have to assume the OP means the 16MF?
D16MF.gif
I could be wrong, but it looks to me like KM-1650/2550.
Its definitely KM1650!
Change toner and vac the dev unit!
Also check contacts on transfer roller and clean pressure roller with fuser cleaning cloth!
Byting on bits.
Firmwares HERE.OK Google! ... will I need Berrocca this morning?
The D16 was the same machine as the KM-1620. Kyo-fan is correct. Ancient machine, but a great one.
Everything that has a beginning, has an end.....
Thanks: 
Likes: 
Reply With Quote
Bookmarks