Kyocera FS C8520 MFP Jamming in Vertical Transport

[docfeeder]

Hi All

I have an issues with jamming in the vertical transport section on a Kyocera FS C8520. I have cleaned the vertical sensor. The paper gets to the transfer belt/ transfer roller and then just folds and jams in that area every time. I have run up the machine with the door open and noticed the transfer belt either does not turn or stops/starts in a jerking movement. The drive motor turns, so I am guessing the problem is in the drive assembly or clutch?

Has anyone else had this problem ? Is it a known issue ? And do you have to replace the complete drive assembly?

Thanks

Kevin

[KdvA]

most likely a defective "middle transfer drive shaft".

[blackcat4866]

jam code? =^..^=

[tmaged]

http://www.copytechnet.com/forums/ky...lding-jam.html

The search function is your friend.

[serviceman678]

Hi All

I have an issues with jamming in the vertical transport section on a Kyocera FS C8520. I have cleaned the vertical sensor. The paper gets to the transfer belt/ transfer roller and then just folds and jams in that area every time. I have run up the machine with the door open and noticed the transfer belt either does not turn or stops/starts in a jerking movement. The drive motor turns, so I am guessing the problem is in the drive assembly or clutch?

Has anyone else had this problem ? Is it a known issue ? And do you have to replace the complete drive assembly?

Thanks

Kevin

check the toner recycling system if the auger get jam this will happen also if the fuser doesnt come to the proper temp this will also happen but you need a spare fuser for