Thanks Thanks:  0
Dislikes Dislikes:  0
Results 1 to 4 of 4
  1. #1
    Trusted Tech 50+ Posts
    Join Date
    Oct 2016
    Location
    manila
    Posts
    96
    Rep Power
    0

    Unhappy Kyocera fs6525mfp

    Hi i am new for kyocera reparing this machine i encounter problem for fuser unit i have cleaned the area for exit tray there are lots of sensor if i going to copy single side its fine but if double sided the paper was jam in the fuser unit i thought the fuser lower roller is the problem. Any suggestion before i replace it.? Thanks in advance.....


  2. #2
    Master Of The Obvious 10,000+ Posts
    Kyocera fs6525mfp

    blackcat4866's Avatar
    Join Date
    Jul 2007
    Location
    Lapeer, Michigan
    Posts
    15,331
    Rep Power
    247

    Re: Kyocera fs6525mfp

    What jam code? =^..^=

    If you'd like a serious answer to your request:
    1) demonstrate that you've read the manual
    2) demonstrate that you made some attempt to fix it.
    3) if you're going to ask about jams include the jam code.
    4) if you're going to ask about an error code include the error code.


    blackcat: Master Of The Obvious =^..^=

  3. #3
    Trusted Tech 50+ Posts
    Join Date
    Oct 2016
    Location
    manila
    Posts
    96
    Rep Power
    0

    Re: Kyocera fs6525mfp

    Quote Originally Posted by blackcat4866 View Post
    What jam code? =^..^=
    the jam code appeared on screen was jam 0508 from the area eject section going to to duplex, sometimes was stuck on fuser unit possible the fuser lower roller is having problem or the sensor from the middle of eject upper section assembly...


  4. #4
    Senior Tech 250+ Posts
    Kyocera fs6525mfp


    Join Date
    May 2009
    Location
    Concord, NH
    Posts
    297
    Rep Power
    23

    Re: Kyocera fs6525mfp

    A jam code of 0508 indicates that the paper is not reaching the registration sensor in the allotted time when in duplex. Since you say single sided copies are OK, I would suspect that the rollers in the switchback section have become glazed and are slipping causing the paper to not reach the registration sensor in time causing the code. I would not suspect the fuser unit as single sided copies do not cause a jam code and you do not get a code for the switchback sensor. Since the switchback sits right above the fuser, the "rubber" rollers are subjected to quite a bit of heat that can dry them out causing them to slip. Simply cleaning them [not with alcohol] in most cases will restore them. Hope this helps.


Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here