Kyocera TASKalfa 8001i

[Sergey1985]

Good afternoon.
When you turn on the MFPs error occurs C7460
How can i solve this problem?

[Where is my screwdriver]

Good afternoon.
When you turn on the MFPs error occurs C7460
How can i solve this problem?

The inner unit will become contaminated with toner spill. Best to replace the whole unit.

302LF94043 PARTS INNER UNIT SP

[Geo]

Good afternoon.
When you turn on the MFPs error occurs C7460
How can i solve this problem?

Most likely the shutter release sensor is dirty. If it is , why? Is the copier running dirty, worn DV unit or simply poor maintenance/cleaning during S.C.
Good luck.

[Sergey1985]

Thanks for the answer, but this error on the two new devices out of the box.
The waste toner box goes to the base with the MFP.
Where to find this sensor or what needs to be moved?

[Sergey1985]

picture

[Where is my screwdriver]

Thanks for the answer, but this error on the two new devices out of the box.
The waste toner box goes to the base with the MFP.
Where to find this sensor or what needs to be moved?

Make sure the connector is plugged in on the inner unit. It is behind the flap next to the left of the toner cartridge.

[Where is my screwdriver]

Make sure the connector is plugged in on the inner unit. It is behind the flap next to the left of the toner cartridge.

Also have you released the developer shutter fixing pin as in the installation instructions?

[Sergey1985]

How can I find this inner unit?
The equipment was assembled without a service engineer, and when turned on, there was an error.
With MFP, all tapes were removed from the outside and from the trays

[Where is my screwdriver]

Open the front door and release the shutter pin. This needs to be done before you can use the machine as it locks the developer unit to stop spillage during delivery.

[Geo]

How can I find this inner unit?
The equipment was assembled without a service engineer, and when turned on, there was an error.
With MFP, all tapes were removed from the outside and from the trays

OK..Most likely the developer shutter was not released. See page 1-2-26 in the service manual and I would retrace/redo all the set up steps .